← Apple Interview InsightsSoftware Engineer

Apple·Software Engineer·Technical Phone Screen·Senior

Senior
Jun 2026

Summary

Apple hardware interview with a product-design exercise that was more systems-thinking than I expected. The whole thing centered on thermal modeling using an electrical resistance analogy, which sounds niche but ended up covering a lot of ground around how you structure a module, define its boundaries, and plug it into a bigger system.

Questions Asked (1)

Q1

Design a thermal conduction system module using an equivalent electrical resistance analogy. Walk through how you'd identify the relevant thermal resistances (conductive, convective, radiative), set boundary conditions, account for heat sources, and define how this module interfaces with other thermal blocks in a larger system.

System DesignTechnical Trade-offs
Author's notes

This one took me a second to orient.

Create a free account to read the full note

AI HintsAI Generated

Suggested Approach

Start by framing the problem as a lumped-parameter thermal network where temperature is analogous to voltage and heat flow to current. Then systematically derive each thermal resistance (conduction, convection, radiation), define boundary conditions and heat sources, and finally describe the module's interface as a reusable component with defined ports and parameters. Emphasize modularity, numerical stability, and validation against analytical or experimental data.

Pro tip: Mention that radiative resistance is nonlinear (depends on T^3) and often linearized around an operating point; also highlight the importance of consistent sign conventions and reference temperatures to avoid integration errors in system-level simulations.

1. Define the thermal network and analogies

Map temperature to voltage, heat flow to current, and thermal resistance to electrical resistance. Identify nodes (isothermal regions) and branches (heat flow paths) for the module.

2. Derive thermal resistances

For each heat transfer mode, write the resistance formula: conduction R = L/(kA), convection R = 1/(hA), radiation R = 1/(h_rad A) with h_rad = εσ(T_s^2 + T_sur^2)(T_s + T_sur). Note nonlinearity and linearization.

3. Set boundary conditions and heat sources

Specify fixed temperatures (e.g., ambient, heat sink) and heat generation terms (e.g., power dissipation) at appropriate nodes. Ensure units and reference temperatures are consistent.

4. Formulate and solve the system

Assemble the conductance matrix (or resistance network) and solve for node temperatures using linear algebra (if linear) or iterative methods (if nonlinear). Discuss numerical stability and time-stepping for transient analysis.

5. Define module interface and integration

Expose the module as a component with input/output ports (e.g., heat flow, temperature) and parameters (resistances, capacitances). Describe how it connects to other thermal blocks (e.g., series/parallel) and how it can be co-simulated with electrical/mechanical domains.

Key Points to Mention

  • Electrical-thermal analogy: temperature ↔ voltage, heat flow ↔ current, thermal resistance ↔ electrical resistance, thermal capacitance ↔ electrical capacitance.
  • Conduction resistance formula: R_cond = L/(kA), where L is length, k is thermal conductivity, A is cross-sectional area.
  • Convection resistance: R_conv = 1/(hA), where h is convective heat transfer coefficient.
  • Radiation resistance: nonlinear, R_rad = 1/(h_rad A) with h_rad = εσ(T_s^2 + T_sur^2)(T_s + T_sur); often linearized around an operating point.
  • Boundary conditions: fixed temperature (Dirichlet) or fixed heat flux (Neumann), and heat sources as current injections.
  • Modularity: define ports (e.g., temperature nodes, heat flow) and parameters for reuse; ensure compatibility with other thermal blocks via consistent interfaces.

AI-generated suggestions, not part of the candidate's original notes. May be inaccurate — verify before relying on them.